Migrating an Avaya IP600/S8100 to an S8700-Series Media Server with IP-PNC
838 Upgrading, Migrating, and Converting Media Servers and Gateways
For more information, see Migration paths on page 833.
When you migrate from a DEFINITY system, you must complete the following additional tasks
before you start the migration:
9
Task Description
Determine which adapters
and cables you can reuse.
You cannot reuse the following items:
● The C-LAN 259A adapter. You must use
adapter for IP Media Processor for 100-Mbps
speed.
● The CAT3 cable that is used with C-LAN. You
must use a CAT5 or better cable for 100-Mbps
speed.
CAUTION:
If you are going to use the MOST Tool, the following 8 tasks must be done before
freezing translations or saving translations to an MO disk that will be used to read
translations directly into a media server.
If you want to use STS for translation conversion, see Replace any TN775/B/C
maintenance circuit packs. on page 840.
CAUTION:
Be sure to do this step
before freezing translations.
Remove all Mode II Data
Modules before you change
to the S8700-Series Media
Server.
The S8700-Series Media Server do not support the
following data modules:
● System Ports
● PDMs (7400/8400 Data Modules)
● PktGateway
● Pkt Data Dataline
● Modem Pool
● System CDR PDMs
● System Features Printer PDMs
1 of 3
To Next Page
Loading...
