Migration paths
Issue 2.1 June 2006 839
Be sure to do this step
before you freeze
translations.
The TN750 Announcement
circuit packs are not
supported in the
S8700-Series Media
Servers.
The announcements translations migrate to the
S8700 Series Media Server. However, you must
change the circuit pack locations to the TN2501AP
Voice Announcement over LAN (VAL) circuit pack.
NOTE:
All announcement names must be unique on a
TN2501AP VAL circuit pack. The announcement
names cannot contain any spaces, blanks, or the
following characters:
● forward slash (/)
● colon (:)
● asterisk (*)
● question mark (?)
● backward slash (\)
● angle brackets (<>)
Type change announcements to change any
names and port locations.
CAUTION:
Be sure to do this step
before freezing translations.
On the IP Services screen
in the Service Type field,
remove Alarm1 and
Alarm2.
You first might need to change the System
Parameters Maintenance screen before you can
make any changes to the IP Services screen.
CAUTION:
Be sure to do this step
before freezing translations.
On the Trunk Group
screen, change the
Measured field from
measured to none.
This action indicates that trunk group measurement
reports are not required. Remember to re-measure
trunk groups.
To get a list of the trunk groups that are "measured"
and need to be changed, type list trunk-group.
9
Task Description
2 of 3
To Next Page
Loading...
