Dell S4810 - Redistribute

redistribute
Redistribute routes from one routing domain to another routing domain.
S4810
Syntax
redistribute {static | connected | rip} [level-1 | level-1-2 |
level-2] [metric metric-value] [metric-type {external |
internal}] [route-map map-name]
To end redistribution or disable any of the specified keywords, use the no
redistribute {static | connected | rip} [metric metric-value]
[metric-type {external | internal}] [level-1 | level-1-2 |
level-2] [route-map
map-name] command.
Parameters
connected Enter the keyword connected to redistribute active routes
into IS-IS.
rip Enter the keyword rip to redistribute RIP routes into IS-IS.
static Enter the keyword static to redistribute user-configured
routes into IS-IS.
metric metric-
value
(OPTIONAL) Assign a value to the redistributed route. The
range is from 0 to 16777215. The default is 0. Use a value that
is consistent with the destination protocol.
metric-type
{external |
internal}
(OPTIONAL) The external link type associated with the
default route advertised into a routing domain. Specify one
of the following:
• external
• internal
level-1 (OPTIONAL) Routes are independently redistributed into IS-
IS as Level 1 routes.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-
IS as Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-
IS as Level 2 routes. This setting is the default.
route-map
map-name
(OPTIONAL) If you do not enter the route-map argument, all
routes are redistributed. If a map-name value is not specified,
no routers are imported.
Defaults
• metric metric-value = 0
• metric-type= internal; level-2
Command
Modes
• ROUTER ISIS (for IPv4)
Intermediate System to Intermediate System (IS-IS)
1009