Dell S4810 - Qos-Policy-Output

qos-policy-output
Create a QoS output policy.
S4810
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-
name
Enter your output QoS policy name in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Use this command to specify the name of the output QoS policy. Once output
policy is specified, rate-shape, scheduler strict, bandwidth-percentage, and WRED
can be defined. This command enables the qos-policy-output configuration mode
—(conf-qos-policy-out).
When rate-shape in QoS policy is applied both on queue level and aggregate
mode, the queue-based shaping occurs first followed by the aggregate rate
shaping.
Related
Commands
bandwidth-percentage — assigns weight to the class/queue.
wred — assigns yellow or green drop precedence.
Quality of Service (QoS)
1361