Pkts, 0 Error Traffic Class
TLV
Pkts
show qos dcb-output
Displays the ETS configuration in a DCB output policy.
S4810
Syntax
show qos dcb-output [ets-profile]
Parameters
[ets-profile] Enter the ETS profile.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Example
(Summary)
Dell# show qos dcb-output
dcb-output ets
priority-group san qos-policy san
priority-group ipc qos-policy ipc
priority-group lan qos-policy lan
show qos priority-groups
Displays the ETS priority groups configured on the switch, including the 802.1p priority classes and ID of
each group.
S4810
Syntax
show qos priority-groups
Data Center Bridging (DCB)
555
To Next Page
Loading...
