seq 5 deny ip any 191.1.0.0 /16 count (0x00 packets)
seq 10 deny ip any 191.2.0.0 /16 order 4
seq 15 deny ip any 191.3.0.0 /16
seq 20 deny ip any 191.4.0.0 /16
seq 25 deny ip any 191.5.0.0 /16
Dell#show ip accounting access-list L3-ACL vrf vrf3
!
Standard Ingress IP access list L3-ACL on vrf3
Total cam count 3
seq 5 permit 10.1.2.0/24
seq 10 permit 20.1.2.0/24
seq 15 permit 30.1.2.0/24
Dell#
show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and
the count of matches/mismatches against each ACL entry displayed.
S4810
Syntax
show ip access-lists [access-list-name] [interface interface]
[in | out] [vrf vrf-name]
Parameters
access-list-
name
Enter the name of a configured MAC ACL, up to 140
characters.
interface
interface
Enter the keyword interface followed by the one of the
following keywords and slot/port or number information:
• For a VLAN interface, enter the keyword vlan followed
by the slot/port number.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For a Port Channel interface, enter the keyword port-
channel
followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is
1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet
followed by the slot/ port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
in | out Identify whether ACL is applied on the ingress or egress side.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
display the access-lists that are configured on either the
default or non-default VRFs.
Access Control Lists (ACL)
213
To Next Page
Loading...
