Dell S4810 - Ipv6 Router Ospf

Parameters
number
Enter the number as the priority. The range is from 1 to 255.
Defaults 1
Command
Modes
INTERFACE
Command
History
Version 9.1.
(0.0)
Introduced on the S4810 and Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Setting a priority of 0 makes the router ineligible for election as a Designated
Router or Backup Designated Router.
Use this command for interfaces connected to multi-access networks, not point-
to-point networks.
ipv6 router ospf
Enable OSPF for IPv6 router configuration.
S4810
Syntax
ipv6 router ospf process-id
To exit OSPF for IPv6, use the no ipv6 router ospf process-id command.
Parameters
process-id
Enter the process identification number. The range is from 1
to 65535.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced on the S4810 and Z9000.
1256
Open Shortest Path First (OSPFv2 and OSPFv3)