Dell S4810 - ETS Commands; Bandwidth-Percentage

Example
(Summary)
Dell(conf)# show stack-unit all stack-ports all pfc details
stack unit 0 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
stack unit 1 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
ETS Commands
The following ETS commands are supported on the S4810 platform.
bandwidth-percentage
Configure the bandwidth percentage allocated to priority traffic in port queues.
S4810
Syntax
bandwidth-percentage percentage
To remove the configured bandwidth percentage, use the no bandwidth-
percentage
command.
Parameters
percentage (Optional) Enter the bandwidth percentage. The percentage
range is from 1 to 100% in units of 1%.
Defaults none
Command
Modes
QOS-POLICY-OUT-ETS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Data Center Bridging (DCB)
537