Related
Commands
show gvrp statistics — displays the GVRP statistics.
debug gvrp
Enable debugging on GVRP.
S4810
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the no debug gvrp {config | events | pdu}
command.
Parameters
config Enter the keyword config to enable debugging on the
GVRP configuration.
event Enter the keyword event to enable debugging on the JOIN/
LEAVE events.
pdu Enter the keyword pdu then one of the following Interface
keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Disabled.
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
GARP VLAN Registration (GVRP)
689
To Next Page
Loading...
Need help?
General
