Dell S4810 - 42 PIM-Sparse Mode (PIM-SM)

42
PIM-Sparse Mode (PIM-SM)
The protocol-independent multicast (PIM) commands are supported by the Dell Networking operating
software on the S4810 platform.
IPv4 PIM-Sparse Mode Commands
The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.
clear ip pim rp-mapping
The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP)
advertisement.
S4810
Syntax
clear ip pim rp-mapping rp-address
Parameters
rp-address (OPTIONAL) Enter the RP address in dotted decimal format
(A.B.C.D).
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the S-Series.
PIM-Sparse Mode (PIM-SM)
1281