Dell S4810 - Disable

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
disable
Enable or disable LLDP.
S4810
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
debug lldp interface — debugs LLDP.
1084
Link Layer Discovery Protocol (LLDP)