Dell S4810 - Snmp-Server Packetsize

snmp-server packetsize
Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a
reply, use the snmp-server packetsize global configuration command.
S4810
Syntax
snmp-server packetsize byte-count
Parameters
byte-count Enter one of the following values 8, 16, 24 or 32. Packet sizes
are 8000 bytes, 16000 bytes, 32000 bytes, and 64000 bytes.
Defaults 8
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server trap-source
Configure a specific interface as the source for SNMP traffic.
S4810
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, use the no snmp trap-source
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
Simple Network Management Protocol (SNMP) and Syslog
1571