Dell S4810 - Ip Unknown-Unicast

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies the service-policy based on the type of protocol defined in
the ACL rules.
Create ACL and QoS policies prior to enabling this command.
For CoPP, use the keyword cpu-qos when creating qos-policy-input.
Related
Commands
ip access-list extended — creates an extended IP ACL.
mac access-list extended — creates an extended MAC ACL.
qos-policy-input — creates a QoS input policy map.
class-map — creates a QoS class map.
policy-map-input — creates an input policy map.
ip unknown-unicast
Enable IPv4 catch-all route.
S4810
Syntax
ip unknown-unicast [vrf vrf-name]
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding
table in hardware which gets added as a default configuration after the initialization
of FIB Agent module, use the no ip unknown-unicast command.
Defaults None
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of
the VRF to enable catch-all routes corresponding to that
VRF.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0) Introduced on the S–Series.
Control Plane Policing (CoPP)
513