clear ipv6 ospf process
Reset an OSPFv3 router process without removing or re-configuring the process.
S4810
Syntax
clear ipv6 ospf process
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced on the S4810 and Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 7.8.1.0 Added support for C-Series.
Version 7.4.1.0 Introduced on the E-Series.
debug ipv6 ospf bfd
Display debug information and interface types for bidirectional forwarding detection (BFD) on OSPF IPv6
packets.
S4810
Syntax
[no] debug ipv6 ospf bfd [interface]
Parameters
interface
(OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a tunnel interface, enter the keyword tunnel then a
number. The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Open Shortest Path First (OSPFv2 and OSPFv3)
1241
To Next Page
Loading...
