Dell S4810 - Match Community

Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set as-path — adds information to the BGP AS_PATH attribute.
match community
To match routes that have a certain COMMUNITY attribute in their BGP path, configure a filter.
S4810
Syntax
match community community-list-name [exact]
To delete a community match filter, use the no match community command.
Parameters
community-
list-name
Enter the name of a configured community list.
exact (OPTIONAL) Enter the keywords exact to process only
those routes with this community list name.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Access Control Lists (ACL)
273