Dell S4810 - Dei Mark

Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the C-Series and S-Series.
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
dei enable — Make packets eligible for dropping based on their DEI value.
dei mark
Set the DEI value on egress according to the color currently assigned to the packet.
S4810
Syntax
dei mark {green | yellow} {0 | 1}
Parameters
0 | 1 Enter the bit value you want to map to a color.
green | red |
yellow
Choose a color:
• Green: High priority packets that are the least preferred
to be dropped.
• Yellow: Lower priority packets that are treated as best-
effort.
Defaults All the packets on egress are marked with DEI 0.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
VLAN Stacking
1693