Dell S4810 - Show Ip Udp-Helper

show ip udp-helper
Display the configured UDP helpers on all interfaces.
S4810
Syntax
show ip udp-helper
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Pre-version
8.3.7.0
Introduced on the E-Series ExaScale.
Example
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
Gi 10/0 656, 658
Gi 10/1 All
Related
Commands
debug ip udp-helper — enables debug and displays the debug information on a
console.
ip udp-broadcast-address — configures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface either
for all UDP ports or a specified list of UDP ports.
826
Interfaces