clear ip pim tib
Clear PIM tree information from the PIM database.
S4810
Syntax
clear ip pim tib [group]
Parameters
group (OPTIONAL) Enter the multicast group address in dotted
decimal format (A.B.C.D).
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the S-Series.
Usage
Information
If you use this command on a local VLT node, all multicast routes from the local
PIM TIB, the entire multicast route table, and all the entries in the data plane are
deleted. The local VLT node sends a request to the peer VLT node to download
multicast routes learned by the peer. Both local and synced routes are removed
from the local VLT node multicast route table. The peer VLT node clears synced
routes from the node.
If you use this command on a peer VLT node, only the synced routes are deleted
from the multicast route table.
debug ip pim
View IP PIM debugging messages.
S4810
Syntax
debug ip pim [bsr | events | group | packet [in | out] |
register | state | timer [assert | hello | joinprune |
register]]
1282
PIM-Sparse Mode (PIM-SM)
To Next Page
Loading...
Need help?
General
