Dell S4810 - Permit

Version 7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
Version 6.5.1.0 Expanded to include the optional QoS order priority for the
ACL entry.
Usage
Information
Dell Networking OS supports one ingress and one egress IP ACL per interface.
Prior to Dell Networking OS version 7.8.1.0, names are up to 16 characters long.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related
Commands
ip access-list extended — creates an extended access list.
show config — displays the current configuration.
permit
To permit packets from a specific source IP address to leave the switch, configure a filter.
S4810
Syntax
permit {source [mask]| any | host ip-address}
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no permit {source [mask] | any | host ip-address}
command.
Parameters
source Enter the IP address in dotted decimal format of the network
from which the packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject
to the filter. You can enter any of the following keywords to
specify route types.
• bytes — Enter the keyword bytes to count bytes
processed by the filter.
• count — Enter the keyword count to count packets the
filter processes.
• dscp — Enter the keyword dcsp to match to the IP
DCSCP values.
Access Control Lists (ACL)
217