Dell S4810 - Show Mac Accounting Destination

Example
Dell#show mac-address-table aging-time
Mac-address-table aging time : 1800
Dell#
Related
Commands
show mac-address-table — displays the current MAC address configuration.
show mac accounting destination
Display destination counters for Layer 2 traffic (available on physical interfaces only).
S4810
Syntax
show mac accounting destination [mac-address vlan vlan-id]
[interface interface [mac-address vlan vlan-id] [vlan vlan-id]]
[vlan vlan-id]
Parameters
mac-address (OPTIONAL) Enter the MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that
MAC address.
interface
interface
(OPTIONAL) Enter the keyword interface then the
interface type, slot and port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to
display the MAC address assigned to the VLAN. The range is
from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
pre-Version
6.2.1.1
Introduced on the E-Series.
1054
Layer 2