Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.2
Added support for the access parameter.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The following Example specifies the group named harig as a version 3 user
requiring both authentication and encryption and read access limited to the read
named rview.
NOTE: The number of configurable groups is limited to 16 groups.
Example
Dell#conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related
Commands
show snmp group — displays the group name, security model, view status, and
storage type of each group.
show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
S4810
Syntax
snmp-server host ip-address | ipv6-address [vrf vrf-name] traps
| informs [version 1 | 2c | 3] [auth | no auth | priv]
[community-string] [udp-port port-number] [notification-type]
1566
Simple Network Management Protocol (SNMP) and Syslog
To Next Page
Loading...
