Dell S4810 - Clear Dampening

clear dampening
Clear the dampening counters on all the interfaces or just the specified interface.
S4810
Syntax
clear dampening [interface]
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number to clear counters from a specified interface:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Without an interface specified, the command clears all interface dampening
counters.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
After you enter the clear counters command and verify the results with the
show interfaces command, the line rate is not reset to 0.00%.
Example
Dell#clear dampening tegigabitethernet 1/2
Clear dampening counters on TeGi 1/2 [confirm] y
Dell#
Interfaces
741