Dell S4810 - Show Ipv6 Neighbors

interface
interface
Enter the keyword interface then the interface type and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
hardware_addr
ess
Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn
format.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the control processor (CP).
S4810
Syntax
show ipv6 neighbors [ipv6-address] [cpu {rp1 [ipv6-address] |
rp2 [ipv6-address]}] [interface interface]
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
Neighbor Discovery Protocol (NDP)
1153