Dell S4810 - Interface Group

interface group
Create or delete group of VLANs with a single command. You can also use this command to apply a set
of configurations on a group of interfaces.
S4810
Syntax
interface group [fortyGigE slot/port { - port }|
gigabitethernet slot/port { - port }| tengigabitethernet slot/
port { - port } | vlan vlanid {- vlanid } ]
To delete a range of VLANs, use the following command: no interface group
vlan vlanid {- vlanid}
Parameters
interface,
interface,...
Enter the keywords interface group and one of the
interfaces — slot/port or VLAN number. Select the range of
interfaces for bulk configuration. Spaces are not required
between the commas. Comma-separated ranges can
include VLANs and physical interfaces.
Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a
single VLAN ID, or a combination. For example: VLAN IDs
(comma-separated): 3, 4, 6. Range (hyphen-separated):
5-10.
Slot/Port information need not contain a space before and
after the dash. For example. both of the following
commands are valid: interface group
gigabitethernet 0/1 - 5
; interface group
gigabitethernet 0/1-5.
• For a Gigabit Ethernet interface, enter the keyword
gigabitethernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
750
Interfaces