ip msdp mesh-group
To be a member of a mesh group, configure a peer.
S4810
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group
{name} {peer address} command.
Parameters
name Enter a string of up to 16 characters long for as the mesh
group name.
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
Usage
Information
An MSDP mesh group is a mechanism for reducing SA flooding, typically in an
intra-domain setting. When some subset of a domain’s MSDP speakers are fully
meshed, they can be configured into a mesh-group. If member X of a mesh-group
receives a SA message from an MSDP peer that is also a member of the mesh-
group, member X accepts the SA message and forwards it to all of its peers that are
not part of the mesh-group. However, member X cannot forward the SA message
to other members of the mesh-group.
Multicast Source Discovery Protocol (MSDP)
1115
To Next Page
Loading...
