dcb-buffer-threshold
Configure the profile name for the DCB buffer threshold. This utility is supported on the S4810, S4820T,
and S6000 platforms.
S4810
Syntax
dcb buffer—threshold profile-name
Parameters
profile-name Enter the name of the profile, which can be a string of up to
32 characters in length.
Default None
Command
Modes
CONFIGURATION mode
Command
History
Version 9.3(0.0) Introduced on the S4810, S4820T, and S6000 platforms.
Usage
Information
When you enter the profile name, you enter the DCB buffer threshold
configuration mode. You can specify the shared buffer threshold limit, the ingress
buffer size, buffer limit for pausing the acceptance of packets, and the buffer offset
limit for resuming the acceptance of received packets.
Example
S4810-YU-MR-Dell(conf)#dcb buffer—threshold test
priority
Configure the priority for the PFC threshold to be allocated to the buffer space parameters. This utility is
supported on the S4810 platforms.
Syntax
priority value buffer-size size pause-threshold threshold-value
resume-offset threshold-value shared-threshold-weight size
Parameters
priority Specify the priority of the queue for which the buffer space
settings apply
value Enter a number in the range of 0 to 7 to denote the priority
to be allocated to the dynamic buffer control mechanism
buffer-size Ingress buffer size
size Size of the ingress buffer in KB. Enter a number in the range
of 0 to 7787. The default is 45 KB.
pause-
threshold
Buffer limit for pause frames to be sent
threshold-
value
Buffer limit at which the port sends the pause to peer in KB.
Enter a number in the range of 0 to 7787. The default is 10
KB.
Data Center Bridging (DCB)
579
To Next Page
Loading...
