Dell S4810 - Show Running-Config Ecmp-Group; Shutdown

Example
Dell(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
Dell(conf-if-range-so-2/0-1,fa-0/0)#
Related
Commands
interface — configures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specific physical interface or virtual
interface.
show running-config ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the
ecmp-group monitoring enable command. The ECMP group could have a LAG or a list of 10G/40
interfaces (not just LAG link-bundles).
S4810
Syntax
show running-config ecmp-group
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.0
Introduced on the S4810.
Related
Commands
ecmp-group — configures a mechanism to monitor traffic distribution.
shutdown
Disable an interface.
S4810
Syntax
shutdown
To activate an interface, use the no shutdown command.
796
Interfaces