Dell S4810 - Restore Factory-Defaults

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series Original command
restore factory-defaults
Restore factory defaults.
S4810
Syntax
restore factory-defaults stack-unit {0-5 | all} {clear-all |
nvram}
Parameters
factory-
defaults
Return the system to its factory default mode.
0-5 Enter the stack member unit identifier to restore only the
mentioned stack-unit.
all Enter the keyword all to restore all units in the stack.
clear-all Enter the keywords clear-all to reset the NvRAM and the
system startup configuration.
nvram Enter the keyword nvram to reset the NvRAM only.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
72
File Management