Dell S4810 - Show Config; Show Config (from INTERFACE RANGE Mode)

show config
Display the interface configuration.
S4810
Syntax
show config
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Example
Dell(conf-if-fo-0/4)#show config
!
interface fortyGigE 0/4
no ip address
mtu 12000
switchport
no shutdown
Dell(conf-if-fo-0/4)#
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
S4810
Syntax
show config
Command
Modes
CONFIGURATION INTERFACE (conf-if-range)
772
Interfaces