Dell S4810 - Ipv6 Flowlabel-Zero; Ipv6 Host

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
S4810
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the field and allow the rotocol operations to fill
the field, use the no ipv6 flowlabel-zero command.
Default Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
If the flowlabel value is already set for BGP or SSH, the system defaults to the
already configured value. All packets on the same connection are considered part
of the same flow by the system. For new connections, set the new flowlabel to
zero.
ipv6 host
Assign a name and IPv6 address the host-to-IPv6 address mapping table uses.
S4810
Syntax
ipv6 host name ipv6-address
To remove an IP host, use the no ipv6 host name {ipv6–address}.
IPv6 Basics
931