Dell S4810 - Ip Msdp Default-Peer

Parameters
number Enter the number of rejected SA entries to cache. The range
is from 0 to 32766.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
Related
Commands
show ip msdp sa-cache rejected-sa
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
S4810
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer
address
} list name command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard
access list that contains the RP address that should be
treated as the default peer. If no access list is specified, then
all SAs from the peer are accepted.
Defaults Not configured.
Command
Modes
CONFIGURATION
Multicast Source Discovery Protocol (MSDP)
1113