Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
A route reflector reflects routes to the neighbors assigned to the cluster. Neighbors
in the cluster do not need not to be fully meshed. By default, when you use no
route reflector
, the internal BGP (IBGP) speakers in the network must be fully
meshed.
The first time you enter this command, the router configures as a route reflector
and the specified BGP neighbors configure as clients in the route-reflector cluster.
When you remove all clients of a route reflector using the no neighbor route-
reflector-client command, the router no longer functions as a route
reflector.
If the clients of a route reflector are fully meshed, you can configure the route
reflector to not reflect routes to specified clients by using the no bgp client-
to-client reflection command.
This command automatically restarts the neighbor session for the configuration to
take effect.
Related
Commands
bgp client-to-client reflection — enables route reflection between the route
reflector and the clients.
neighbor sender-side-loopdetect
Enables sender-side loop detection for BGP.
S4810
Syntax
neighbor {ip-address | peer-group-name} sender-side-loopdetect
Border Gateway Protocol
437
To Next Page
Loading...
