Dell S4810 - Interface

interface
Configure the primary, secondary, and control-vlan interfaces.
S4810
Syntax
interface {primary interface secondary interface control-vlan
vlan-id}
To return to the default, use the no interface {primary interface
secondary interface control-vlan vlan-id} command.
Parameters
primary
interface
Enter the keyword primary to configure the primary
interface then one of the following interfaces and slot/port
information:
• Fast Ethernet interface: enter the keyword
FastEthernet then the slot/port information.
• Port Channel interface: enter the keyword port-
channel
then a number. The range is from 1 to 128.
• 10-Gigabit Ethernet interface: enter the keyword
TenGigabitEthernet then the slot/port information
• 40-Gigabit Ethernet interface: enter the keyword
fortyGigE then the slot/port information
secondary
interface
Enter the keyword secondary to configure the secondary
interface then one of the following interfaces and slot/port
information:
• Fast Ethernet interface: enter the keyword
FastEthernet then the slot/port information.
• Port Channel interface: enter the keyword port-
channel then a number. The range is from 1 to 128.
• 10-Gigabit Ethernet interface: enter the keyword
TenGigabitEthernet then the slot/port information
• 40-Gigabit Ethernet interface: enter the keyword
fortyGigE then the slot/port information
control-vlan
vlan-id
Enter the keyword control-vlan then the VLAN ID. The
range is from 1 to 4094.
Defaults none
Command
Modes
CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Force10 Resilient Ring Protocol (FRRP)
679