Dell S4810 - Iscsi Priority-Bits; Show Interface Dcbx Detail

iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
S4810
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits
command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x10
Command
Modes
PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command is available at the global level only.
show interface dcbx detail
Displays the DCBX configuration on an interface.
S4810
Syntax
show interface port-type slot/port dcbx detail
Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
Command
Modes
EXEC Privilege
564
Data Center Bridging (DCB)