Dell S4810 - Iscsi Priority-Bits

Parameters
enable Enter the keyword enable to enable the iSCSI optimization
feature.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on MXL 10/40GbE Switch IO Module.
iscsi priority-bits
Configure the priority bitmap that advertises in the iSCSI application TLVs.
S4810
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits
command.
Defaults 4 (0x10 in the bitmap)
Command
Modes
PROTOCOL LLDP (only on the global, not on the interface)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
954
iSCSI Optimization