Parameters
level (OPTIONAL) Indicate a value from 0 to 7 or enter one of the
following parameters: emergencies, alerts, critical,
errors, warnings, notifications, informational, or
debugging. The default is 7 or debugging.
Defaults level = 7; size = debugging
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
clear logging — clears the logging buffer.
default logging console — returns the logging console parameters to the default
setting.
show logging — displays the logging setting and system messages in the internal
buffer.
logging facility
Configure the Syslog facility used for error messages sent to Syslog servers.
S4810
Syntax
logging facility [facility-type]
To return to the default values, use the no logging facility command.
Parameters
facility-type (OPTIONAL) Enter one of the following parameters:
1586
Simple Network Management Protocol (SNMP) and Syslog
To Next Page
Loading...
