Dell S4810 - Exit

Parameters
minutes Enter the number of minutes of inactivity on the system
before disconnecting the current session. The range is from
0 to 35791. The default is 10 minutes for the console line
and 30 minutes for the VTY line.
seconds (OPTIONAL) Enter the number of seconds. The range is from
0 to 2147483. The default is 0 seconds.
Defaults 10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
To remove the time interval, enter exec-timeout 0 0.
Example
Dell con0 is now available
Press RETURN to get started.
Dell>
exit
Return to the lower command mode.
S4810
Syntax
exit
Command
Modes
• EXEC Privilege
• CONFIGURATION
Control and Monitoring
103