Dell S4810 - Show System Stack-Ports

Stack-unit SW Version: 7.7.1.0
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Enabled
Auto failover limit: 3 times in 60 minutes
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count: 0
Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
Stack Unit Config: succeeded Jul 11 2012 09:42:35
Start-up Config: succeeded Jul 11 2012 09:42:35
Runtime Event Log: succeeded Jul 11 2012 09:42:35
Running Config: succeeded Jul 11 2012 09:42:35
ACL Mgr: succeeded Jul 11 2012 09:42:35
LACP: no block sync done
STP: no block sync done
SPAN: no block sync done
Related
Commands
redundancy disable-auto-reboot – prevents the system from auto-rebooting if it
fails.
show system stack-ports
Display information about the stacking ports on all switches in the stack.
S4810
Syntax
show system stack-ports [status | topology]
Parameters
status (OPTIONAL) Enter the keyword status to display the
command output without the Connection field.
topology (OPTIONAL) Enter the keyword topology to limit the table
to just the Interface and Connection fields.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1610
Stacking