Dell S4810 - Show Qos Policy-Map

Version
8.3.12.0
Introduced on the S4810.
Related
Commands
service-class dot1p-mapping — Identifies the class map.
show qos policy-map
View the QoS policy map information.
S4810
Syntax
show qos policy-map {summary [interface] | detail}
Parameters
summary
interface
To view a policy map interface summary, enter the keyword
summary and optionally one of the following keywords and
slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
detail interface To view a policy map interface in detail, enter the keyword
detail and optionally one of the following keywords and
slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Quality of Service (QoS)
1371