radius-server host — specifies a RADIUS server host.
tacacs-server host — specifies a TACACS+ server host.
access-class
Restrict incoming connections to a particular IP address in a defined IP access control list (ACL).
S4810
Syntax
access-class access-list-name
To delete a setting, use the no access-class command.
Parameters
access-list-
name
Enter the name of an established IP Standard ACL.
Defaults Not configured.
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
line — applies an authentication method list to the designated terminal lines.
ip access-list standard — names (or selects) a standard access list to filter based on
the IP address.
ip access-list extended — names (or selects) an extended access list based on the
IP addresses or protocols.
Security
1463
To Next Page
Loading...
