The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
This feature groups two LAGs to work in tandem as a supergroup. For example, if
one LAG goes down, the other LAG is taken down automatically, providing an
alternate path to reroute traffic, avoiding oversubscription on the other LAG. You
can use both static and dynamic (LACP) LAGs to configure failover groups. For
more information, refer to the “Port Channel” chapter in the Dell Networking OS
Configuration Guide.
Related
Command
group — groups two LAGs in a supergroup (“fate-sharing group”).
show interfaces port-channel — displays information on configured Port Channel
groups.
show config
Display the current configuration of the selected LAG.
S4810
Syntax
show config
Command
Modes
INTERFACE PORTCHANNEL
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
814
Interfaces
To Next Page
Loading...
Need help?
General
