Dell S4810 - Show Cam Pbr

• range = inclusive range of ports (you must specify two
ports for the port command parameter.)
source port Enter the keywords source-port then the port number to
be matched in the ACL rule in the ICAP rule
destination-
port
Enter the keywords destination-port then the port
number to be matched in the ACL rule in the ICAP rule.
source-port-
range
Enter the keywords Source-port-range then the range of
the start port to end port to be matched in the ACL rule in
the ICAP rule.
destination-
port-range
Enter the keywords destination-port-range then the
range of the start port to end port to be matched in the ACL
rule in the ICAP rule.
Defaults none
Command
Modes
REDIRECT-LIST
Command
History
Version 9.4.0.0 Introduced on the S4810.
show cam pbr
Display the PBR CAM content.
S4810
Syntax
show cam pbr {[interface interface] | stack—unit slot-number
port-set number]} [summary]
Parameters
interface
interface
Enter the keyword interface then the name of the
interface.
stack–unit
number
Enter the keyword stack-unit then the slot number. The
range is from 0 to 11 .
port-set
number
Enter the keywords port-set then the port-pipe number.
The range is from 0 to 1.
summary Enter the keyword summary to view only the total number of
CAM entries.
Defaults none
Command
Modes
EXEC
1278
Policy-based Routing (PBR)