Dell S4810 - Neighbor Timers

NOTE: This command is supported in BGP Router Configuration mode for
IPv4 Unicast address only.
Related
Commands
show ip bgp neighbors — displays routes received by a neighbor.
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
S4810
Syntax
neighbor {ip-address | peer-group-name} timers keepalive
holdtime
To return to the default values, use the no neighbor {ip-address | peer-
group-name
} timers command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to set the timers for all
routers within the peer group.
keepalive Enter a number for the time interval, in seconds, between
keepalive messages sent to the neighbor routers. The range
is from 1 to 65535. The default is 60 seconds.
holdtime Enter a number for the time interval, in seconds, between
the last keepalive message and declaring the router dead.
The range is from 3 to 65535. The default is 180 seconds.
Defaults
• keepalive = 60 seconds
• holdtime = 180 seconds
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Border Gateway Protocol
441