Dell S4810 - Show Vrrp

Example
Dell(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active VRRP
group.
S4810
Syntax
show vrrp [vrrp-id] [vrf vrf-name] [interface] [brief][ipv6]
Parameters
vrrp-id (OPTIONAL) Enter the Virtual Router Identifier for the VRRP
group to view only that group. The range is from 1 to 255.
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view active VRRP groups corresponding to that
VRF.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For Port Channel interface types, enter the keywords
port-channel then the number. The range is from 1 to
128.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups.
ipv6 (OPTIONAL) Enter the keyword ipv6 to view only VRRP IPv6
groups.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
1748
Virtual Router Redundancy Protocol (VRRP)