Dell S4810 - Dcb Stack-Unit Pfc-Buffering Pfc-Port-Count Pfc-Queues

To remove only the DCB input policies applied to the specified switch, use the no
dcb-policy input stack-unit command.
Parameters
stack-unit-id Enter the stack unit identification.
dcb-input-
policy-name
Enter the policy name for the DCB input policy.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
The dcb-policy input stack-unit all command overwrites any previous
dcb-policy input stack-unit stack-unit-id configurations. Similarly, a
dcb-policy input stack-unit stack-unit-id command overwrites any
previous dcb-policy input stack-unit all configuration.
Related
Commands
dcb-policy output stack-unit stack-ports all — applies the specified DCB output
policy.
dcb stack-unit pfc-buffering pfc-port-count pfc-queues
Configure the PFC buffer for all port pipes in a specified stack unit by specifying the port-pipe number,
number of PFC-enabled ports, and number of configured lossless queues.
S4810
Syntax
NOTE:
This command was deprecated in Dell Networking OS Version 9.2.(0.0).
524
Data Center Bridging (DCB)