Dell S4810 - Interface Vlan

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.0 Introduced
Example (Single
Range)
This example shows the macro named test that was defined earlier.
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
Dell
Related
Commands
interface range — configures a range of command (bulk configuration).
interface range macro (define) — defines a macro for an interface range (bulk
configuration).
interface vlan
Configure a VLAN. You can configure up to 4094 VLANs.
S4810
Syntax
interface vlan vlan-id [of-instance{of-id}]
Parameters
of-instance{of-
id}
Enter the keyword of-instance then the OpenFlow instance
ID to add the VLAN to the specified OpenFlow instance. The
range is from 1 to 8.
NOTE: Associate the OpenFlow instance with the VLAN
when the VLAN is created. An existing VLAN cannot be
associated with an OpenFlow instance.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Interfaces
759