Dell S4810 - Rate-Police

Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Version 7.4.1.0
and 6.5.3.0
Introduced on the E-Series.
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of
queues. The WRED Curve is applied to all eight ingress Multicast queues.
NOTE: The multicast-bandwidth option is not supported on queue
ingress. If you attempt to use the
multicast-bandwidth option, the
following reject error message is generated: % Error:Bandwidth-percent
is not allowed for ingress multicast.
rate-police
Specify the policing functionality on incoming traffic.
S4810
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of 64.
The range is from 0 to 40000000. The default granularity is
Megabits per second (Mbps).
committed-
rate
Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 40000.
The default is the same as designated for
committed-rate.
Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate.
Granularity for committed-rate and peak-rate is Mbps unless you use the kbps
option.
1364
Quality of Service (QoS)