Dell S4810 - Rmon Collection Statistics

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
rmon collection statistics
Enable RMON MIB statistics collection on an interface.
S4810
Syntax
rmon collection statistics {controlEntry integer} [owner name]
To remove RMON MIB statistics collection on an interface, use the no rmon
collection statistics {controlEntry integer} command.
Parameters
controlEntry
integer
Enter the keyword controlEntry to specify the RMON
group of statistics using a value. Then enter an integer value
from 1 to 65535 that identifies the RMON Statistic Table. The
integer value must be a unique in the RMON statistic table.
owner name (OPTIONAL) Enter the keyword owner then the owner name
to record the owner of the RMON group of statistics.
Defaults none
Command
Modes
CONFIGURATION INTERFACE (config-if)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
1418
Remote Monitoring (RMON)