Dell S4810 - Show Iscsi Session

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on MXL 10/40GbE Switch IO Module.
Example
Dell#show iscsi
iSCSI is enabled
iSCSI session monitoring is disabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860
Related
Commands
• show iscsi session — displays information about active iSCSI sessions on the
switch.
• show iscsi session detailed — displays detailed information about active iSCSI
sessions on the switch.
• show run iscsi — shows run iscsi.
show iscsi session
Display information about active iSCSI sessions on the switch.
S4810
Syntax
show iscsi session
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
iSCSI Optimization
957