Example
(Detail)
Dell#show bfd neighbors detail
Session Discriminator: 1
Neighbor Discriminator: 1
Local Addr: 10.1.3.2
Local MAC Addr: 00:01:e8:02:15:0e
Remote Addr: 10.1.3.1
Remote MAC Addr: 00:01:e8:27:2b:f1
Int: GigabitEthernet 1/3
State: Up
Configured parameters:
TX: 100ms, RX: 100ms, Multiplier: 3
Neighbor parameters:
TX: 250ms, RX: 300ms, Multiplier: 4
Actual parameters:
TX: 300ms, RX: 250ms, Multiplier: 3
Role: Active
Delete session on Down: False
Client Registered: CLI
Uptime: 00:02:04
Statistics:
Number of packets received from neighbor: 376
Number of packets sent to neighbor: 314
Number of state changes: 2
Number of messages from IFA about port state change: 0
Number of messages communicated b/w Manager and Agent: 6
Dell#
Related
Commands
bfd neighbor — establishes a BFD session with a neighbor.
bfd all-neighbors — establishes BFD sessions with all neighbors discovered by the
IS-IS protocol or OSPF protocol out of all interfaces.
vrrp bfd neighbor
Establish a BFD for VRRP session with a neighbor.
S4810
Syntax
vrrp bfd neighbor ip-address
To remove the BFD session with the neighbor, use the no vrrp bfd neighbor
ip-address command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format (A.B.C.D).
Defaults none
Command
Modes
INTERFACE
Bidirectional Forwarding Detection (BFD)
375
To Next Page
Loading...
